YG1 83573TN 1/4″ Size, 1/2″ LOC, 3 Flute, TiN Solid Carbide Finishing End Mill Deal

Applications

Designed for detailed non-ferrous work, the YG1 83573TN 1/4″ diameter, 1/2″ length of cut solid carbide finishing end mill combines a 3-flute design with a 50° helix angle and TiN coating. This setup promotes smooth chip evacuation and reduces built-up edge, enhancing finish quality on aluminum alloys such as 6061 and 6082. Its size and flute count balance reach and stiffness, making it suitable for finishing walls and floors where surface finish is critical. The high helix angle and low-friction TiN coating lower cutting forces and heat generation, minimizing tool wear and improving surface integrity. This combination supports clean cuts and consistent performance in non-ferrous applications, closely aligning with best practices for aluminum finishing. Avoid using this tool on heat-resistant superalloys (HRSA ISO S) because the coating is not a good match and can cause rapid failure. While it can handle some steel and cast iron, its primary strength is in non-ferrous machining, where its properties provide the greatest benefit.

Features

• Designed to machine stainless steel, inconel, titanium and other hard to machine materials.
• It’s 3 flute design gives high stability and allows good chip removal in plunging & slotting operations.
• The high rake angle and 50 degree medium helix allows an extremely wide range of application.
• YG:TYLON super TiAlN coating are recommended for maximum performance.