YG1 83901TF 1/4″ Size, 3/4″ LOC, 3 Flute, YG TiAlN Futura Solid Carbide Finishing End Mill Free Returns

Applications

For precision finishing operations in steel and similar materials, the YG1 83901TF 1/4″ diameter, 3/4″ length of cut solid carbide finishing end mill offers balanced reach and rigidity. Its 3-flute design, 50° helix angle, and TiAlN Futura coating enhance chip evacuation and reduce friction, improving surface finish quality and tool life in demanding applications. This combination supports smooth cutting action and minimizes built-up edge, especially in stainless steel and cast iron. Not suitable for non-ferrous materials, this tools coating unsuitability would cause rapid wear and poor performance. The lack of a corner radius means cutting focuses on sharp edges rather than interrupted cuts where chipping prevention is critical. The synergy between high helix angle and coating aligns well with finishing tasks requiring clean cuts and fine surface finishes. With a geometry and coating pairing optimized for finishing in steel and HRSA materials, this end mill delivers consistent results where precision and surface integrity are priorities. Avoid aluminum and other non-ferrous metals to prevent premature tool failure.

Features

• Designed to machine stainless steel, inconel, titanium and other hard to machine materials.
• It’s 3 flute design gives high stability and allows good chip removal in plunging & slotting operations.
• The high rake angle and 50 degree medium helix allows an extremely wide range of application.
• YG:TYLON super TiAlN coating are recommended for maximum performance.