YG1 83908TC 3/4″ Size, 3″ LOC, 3 Flute, TiCN Solid Carbide Finishing End Mill Shop Now

Applications

The YG1 83908TC 3/4″ Size, 3″ Length of Cut, 3 Flute, TiCN Solid Carbide Finishing End Mill is engineered for finishing tasks that require both rigidity and reach on non-ferrous metals. Its 50° helix angle, combined with a TiCN coating and a three-flute design, delivers smooth, low-friction cutting that minimizes built-up edge and yields clean surface finishes. The tool’s geometry supports efficient chip evacuation while maintaining precision in wall and floor finishing operations. This combination of features aligns well with best practices for machining 6061/6082 aluminum alloys, where a high helix angle and low-friction coating enhance performance. The single-end design and center-cutting ability permit plunge cuts and versatile tool paths, suiting complex contours and pockets. Avoid use on heat-resistant superalloys (HRSA ISO S) due to coating unsuitability, which can cause premature wear. It is not optimized for heavy roughing or hard materials, where other geometries and coatings are preferred.

Features

• Designed to machine stainless steel, inconel, titanium and other hard to machine materials.
• It’s 3 flute design gives high stability and allows good chip removal in plunging & slotting operations.
• The high rake angle and 50 degree medium helix allows an extremely wide range of application.
• YG:TYLON super TiAlN coating are recommended for maximum performance.